Dx6i Programming
Hey Guys,
Not sure if this has been posted, but I can seem to find it..I am converting a Bruder 574 and want to control the hydraulics etc. with my Dx6i.. how do I program the pump to work with the sticks? I have two esc, one for drive(fwd/rev) with 4 gear motors... the other esc for the pump motor...I see some transmitters have a rotary switch to control the pressure..can something similar be done with the Dx6i? How can I program this and will I need two batteries? Many Thanks |
Re: Dx6i Programming
No suggestions? Does anyone use the Dx6i other than for trucks?
Thanks |
Re: Dx6i Programming
Just mix the two channels for the boom and bucket with the channel for the pump esc. With the DX6I that will be the only 2 mixes you have available.
Travis |
Re: Dx6i Programming
Thanks Travis! looks like I may need to upgrade my radio have my eye on the Turnigy 9
On another note, I have been doing some research, do you guys know if it possible to run 4 brushed gear motors with one ESC ? Cheers, Blair |
Re: Dx6i Programming
I have 4 gear motors ran by 1 ESC in my Bruder 574 and it seems to work fine so far.
|
Re: Dx6i Programming
cool any pics? I don't know how you guys manage to jam everything inside these conversions!
|
All times are GMT -4. The time now is 11:39 AM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.