Needfull Things Part 1 ALU Thermo Bottle in 1:14
 

Servus
Caution!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Never work at a rotating Machine if you are not shure what you are doing.
It can be dangerous!!!!!!

Fresh warm Coffee,I like it.
So dont let your Driver work without Coffee.


First,cut a piece of 1,5cm from a 5mm solid round Alum.

http://img6.imageshack.us/img6/3572/...flasche002.jpg
Put it into your Drillstand(Ihave no Lathe)
http://img255.imageshack.us/img255/9...flasche003.jpg
With a File you can Form the Top of the Bottle.
http://img51.imageshack.us/img51/402...flasche004.jpg
With a Saw you cut a small Ring into the Body.
http://img101.imageshack.us/img101/4...flasche005.jpg
http://img535.imageshack.us/img535/8...flasche006.jpg
Turn aruond the Bottle and form the Bottom in the same Way.
Take some Sandpaper and hold it to the rotating Bottle
http://img815.imageshack.us/img815/6...flasche007.jpg
Do it again with a finer Paper.
http://img98.imageshack.us/img98/732...flasche008.jpg
After all you can polish it carefully!!!
http://img340.imageshack.us/img340/1...flasche009.jpg
Your Bottle is ready
http://img813.imageshack.us/img813/5...flasche012.jpg


http://img405.imageshack.us/img405/6...flasche015.jpg

Do you like some Plumcake and Coffee??
Gruss Michael

Re: Needfull Things Part 1 ALU Thermo Bottle in 1:14
 

Great accessories Michael

Re: Needfull Things Part 1 ALU Thermo Bottle in 1:14
 

Very nice, and simple too! Thanks for sharing.

Re: Needfull Things Part 1 ALU Thermo Bottle in 1:14
 

very nice! looked like a .22 bullet before you added the black line! very ingenious!!

Re: Needfull Things Part 1 ALU Thermo Bottle in 1:14
 

Thats what I thought when I had the first one in my Hands.
Maybe a good Idea to make some from solid Silver............

Michael

Re: Needfull Things Part 1 ALU Thermo Bottle in 1:14
 

Perhaps you should make a little handle on the side of the thermos body, and then everyone would know it's not a .22 round. :D