Forum: Highway Trucks and Trailers
01-14-2018, 04:31 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-14-2018, 04:26 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-14-2018, 04:11 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-13-2018, 10:19 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-13-2018, 10:17 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-07-2018, 02:14 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-07-2018, 02:02 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-07-2018, 02:00 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-07-2018, 01:57 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-07-2018, 01:47 PM
|
Replies: 78
Views: 22,074
|
Forum: Highway Trucks and Trailers
01-07-2018, 01:44 PM
|
Replies: 78
Views: 22,074
|
Forum: Electronics tech
12-22-2017, 12:09 PM
|
Replies: 40
Views: 22,914
Re: Beier sound controllerand light setup
OK So, I have the Sound Teacher software open and am on the Configuration tab, on the proportional sounds tab. /i am in mixed mode. I want my turn indicators or blinkers to work with the steering...
|
Forum: Electronics tech
12-22-2017, 11:57 AM
|
Replies: 40
Views: 22,914
Re: Beier sound controllerand light setup
Did the first test with the Taranis Plus. I am confused although the signal for the steering servo goes through, I can not figure out how to program the turn signals to flash and the blinker noise...
|
Forum: Highway Trucks and Trailers
12-22-2017, 11:51 AM
|
Replies: 78
Views: 22,074
|
Forum: Electronics tech
12-21-2017, 09:10 PM
|
Replies: 40
Views: 22,914
Re: Beier sound controllerand light setup
This is the sound module that controls the lights and sounds.
https://farm5.staticflickr.com/4535/24947177158_1654c0e50d_c.jpg
Negative is pulled off the rainbow cable into the resistor...
|
Forum: Electronics tech
12-17-2017, 01:53 PM
|
Replies: 40
Views: 22,914
|
Forum: Sound Systems tech
12-16-2017, 11:52 PM
|
Replies: 13
Views: 9,116
Re: Newbie totally lost
The problem is Tamiya set the low voltage cut off for Nicad or NiMH batteries.
This voltage is FAR TOO LOW to safely use a LiPo!
People will realise this when they see their 1-2K investment...
|
Forum: Electronics tech
12-16-2017, 07:23 PM
|
Replies: 86
Views: 108,868
Re: All About LED's
I need a source for brown red brown and red violet brown resistors.
I am new to the learning curve here.
|
Forum: Electronics tech
12-16-2017, 07:02 PM
|
Replies: 40
Views: 22,914
|
Forum: Electronics tech
12-16-2017, 06:46 PM
|
Replies: 40
Views: 22,914
Re: Beier sound controllerand light setup
I run 3S lipo Packs (I use them in my crawlers, Quad Copters, Airplanes and RC Cars.
That would give 11.2 volts fully charged and cut off at 9.6 volts.
What resistor would you suggest?
|
Forum: General Discussion
12-12-2017, 11:01 PM
|
Replies: 87
Views: 16,156
|
Forum: Electronics tech
12-06-2017, 08:50 PM
|
Replies: 40
Views: 22,914
Re: Beier sound controllerand light setup
The way I see it I have the following circuits for the tractor..
Two bulbs for fog lights, Two bulbs for low beams, Two bulbs for high beams, 7 bulbs for marker lights, one front left turn signal,...
|
Forum: Electronics tech
12-06-2017, 07:36 PM
|
Replies: 86
Views: 108,868
Re: All About LED's
Can somebody PLEASE tell me if this is a correct diagram for wiring up two LEDs to a circuit?
(+resistor-...+LED-...+LED-) if not what do I need to change to make it work correctly?
|
Forum: Electronics tech
12-06-2017, 06:10 PM
|
Replies: 40
Views: 22,914
|
Forum: Electronics tech
12-05-2017, 06:47 PM
|
Replies: 40
Views: 22,914
Re: Beier sound controllerand light setup
I am starting to think that to be able to use all channels on my Taranis Plus, I have to use the ECM-2. I purchased the ECM-2 as well as my USM-RC-2. I understand that the USM-RC-2 can detect the...
|