Re: JD 650H build
Oh and one more important thing, the spindle was getting really really hot. Even after proper spindle bearing break in. Found out that the spindle bearings were loaded too much. Took apart, added some proper grease (not just any but specific bearing grease) and reset the bearing load. Still runs hot on high load side milling but sounds and runs sooooo much smoother. Kind of a p.i.t.a. But a necessary step to get life and good results out of it.
__________________
Always wasting money, as the wife says.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|