Quote:
Originally Posted by RCKiwi
That is impressive! Well done.
|
Thanks!
Quote:
Originally Posted by Lil Giants
What you doing making movies indoors this time of yr Kalle?!
The swivel leak - what threads into the cyl or the hose on the barbed or the swivel joint itself leaks?
|
I know Joe, I have a new job about 2,5 hours from my hometown as of now and when I went home last weekend it was rainy all weekend, that's why!
Hopefully I'm going home soon and hope for good weather this time.
The swivel joint, where it contacts the cylinder body, lower hole on cyl.
It's the M3 one's, there isn't much thread that goes into the cyl and I also don't think that the little o-ring can handle the +20 bars, I got one tight but I think I was lucky there, I need to make a new more bulletproof connector I think, feels like they can start leaking anytime!
Or maybe turn some thin aluminum washers (0.8-1.0mm) instead of the o-rings??