View Single Post
  #2  
Old 09-20-2014, 09:53 AM
mavrick0 mavrick0 is offline
Green Horn
 
Join Date: Apr 2014
Location: Cambridge, ON
Posts: 195
mavrick0 is on a distinguished road
Default Re: Support legs motor voltage?

Travis would be correct that the legs only use 3v. I would try the winch controller at 3v and see what happens before increasing the voltage on the motor and possibly damaging it. If it won't work at 3v then you could always install a large load resistor to drop down the voltage from the minimum 6v that the controller uses to around 3v.
Reply With Quote