Realised I also need to paint the air tanks. So did a quick assembly on that small unit. Good thing too, because doing so pointed out an error I made in the previous post.
Here a pic of the unit;
Screws are M2x4 and M2x8 and M2 nuts. One extra of each fastener.
The little stainless spacer is to make up for the stainless holder to which the fender support is attached.
And here the error I made before. I bolted the fender support to the wrong side of the stainless holder! Aluminum piece supposed to go in front, not behind!
Corrected ... And now easy to see why the little spacer is needed.
And this is how the air tanks will attach later on.
Side note - on the front support for the cab are 2 pieces. The left side on has an attachment for the steering linkage, the right side one doesn't.
That's it for now.
Cheers - Stephan