Thread: setting up transmission positions
View Single Post
  #4  
Old 03-13-2016, 04:03 PM
fhhhstix's Avatar
fhhhstix fhhhstix is offline
Out of control
  
Join Date: Aug 2010
Location: Kirklin IN.
Posts: 3,788
fhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud of
Default Re: setting up transmission positions
Quote:
Originally Posted by stephenk99 View Post
hi

thanks for reply but not as simple as moving end points with the mfu 03 wish it was all the adjustsments are done through a transmission learning routine !!
Sorry I did mis the 03 part and yes it has to be done in the programing section of the trans in the mfu. I did mine in the Cascadia just make sure you have the endpoints set to %100 or it will not calibrate
__________________
AKA "00" Biddle


RIP FreddyGearDrive 2-12-59/12-19-11
Reply With Quote