Thread
:
PC1800 Front Shovel (1/12)
View Single Post
#
215
11-25-2016, 12:44 AM
DADSGARAGE
Apprentice
Join Date: Dec 2013
Location: Northern Alberta CANADA
Posts: 418
Re: PC1800 Front Shovel (1/12)
Really trying to hide any welds, so most of this will be welded on the inside. Only the longer top section will end up being plug welded from the outside.....so I milled a small shoulder on the edges of all three outer plates, doing this also leaves a small lip on all the edges much like the real deal.
The small slots on the front of the bottom plate are to allow the front pivot/hyd. mount plates to be welded on the inside, as well as locate them... (hopefully this will all make more sense later....lol....just need to make a few more parts of the puzzle)
DADSGARAGE
View Public Profile
Find all posts by DADSGARAGE