View Single Post
  #134  
Old 12-14-2017, 07:28 PM
smitty888 smitty888 is offline
Newbie
 
Join Date: Dec 2017
Posts: 1
smitty888 is on a distinguished road
Default Re: 3D Printed D10T Build

I am looking at doing a Tonka bulldozer RC conversion and am considering using the Firgelli/Actuonix actuators. I am wanting to have a two way blade, both raise/lower and swivel left/right. The raise/lower would use two actuators moving in sync like your dozer, but the left/right would require the actuators to move inversely (left extend, right retract). Do you know of a way to do this?
Reply With Quote