Quote:
Originally Posted by Car5858
![Cool](images/smilies/cool.gif) I will be following this build
As for the jumping on the X axis, what are your steps set to, and what operating system is the mill using?
|
soon to get hit with a BFH
![EEK!](images/smilies/eek.gif)
pre dates PC Centurion IV by milltronics no longer supported
![Mad](images/smilies/mad.gif)
there's more then that wrong with it . I think this POS is getting yanked out by next weekend hopefully when the newer 1 comes
![Confused](images/smilies/confused.gif)
and just figure how to do it with the smaller table
![Confused](images/smilies/confused.gif)
this deffinately needs a new control any one need a boat anchor !! Cheap!!!!!