Well now! Back in the saddle again!
First off I guess I'll say thank you for the nice complements.
Finally got the parts I need to finish this baby! EXCEPT for the rims??
Well.......turns out,the wait was for the best.
Now there's a 3 spool in the front of this baby instead of a 2 spool.
Decided to go the bigger buck,& do er up right!
Now the blade will be hydraulic,was gunna go w/servo or screw drive.
But space is at a high cost right now. Turns out,the cab interior had to go bye-bye. Can't run all of this on one pack.
Also gave the cab the skidder look at the back of it.
Now there's a ton of room for ole-mr pumpy.
Also found a nice place to put the speed controller.
Well....Thanks for lookin!
All ball bustin will be takin at par!
FGD