View Single Post
  #23  
Old 04-11-2013, 11:49 PM
CG Bob's Avatar
CG Bob CG Bob is offline
Newbie
 
Join Date: Jul 2011
Location: N.E. Ohio
Posts: 40
CG Bob is on a distinguished road
Default Re: Configure Spectrum DX6i with Tamiya MFU

I was able to finish working on the Scania tonight at the LHS. The owner apparently had some one else do all the electrical work on it, according to our lead car tech. The throttle and fifth wheel release servo leads were swapped in the receiver and those work correctly now. The front turn signal wire plugs were swapped in the MFU and now those work properly. Since the truck didn't have any wheels on it, I wasn't able to do attest drive, but everything seems to check out on the bench.
Reply With Quote