A few months ago I bought a Torcman motor and Jeti spin esc off of a former member. I've been wanting to swap out my noisy planetary drive for this for a while so today I finally got to it. This combo spins the pump a far bit slower but the hydro speed is quite nice and makes it a little easier to operate. I ran it for over 1/2 an hour and the motor was barely warm. The old motor setup would have been hot to the touch in that timespan. I'm not sure what the issue is but sometimes the pump doesn't start when you pull a lever. This happened before with the old setup too but not in the first few months of use. I went to use it a xmas after it had sat a couple months and this started happening. Not sure if something has happened to the gear channel(pump runs of it) or what but the servos still operate the valves...few seconds later and away we go....
Any way here's a couple pics of old and new and a few videos of it in use. I got to use the thumb today a bit too!
Thanks for looking
http://youtu.be/7O_AdIcDoV4 http://youtu.be/WcgubSPQo1k http://youtu.be/Oe-MKykyspw
Reg