I have finally figured the way to make illuminated dash. Hope this short tutorial will help and ''illuminate'' an easy way for everyone to make one if they wish.
[IMG]
Untitled by
Jack Reichman, on Flickr[/IMG]
First step: transfer the decal on to thin piece of acrylic, I used .75mm, trim the excess acrylic.
Step two: black out all the area not to be illuminated, black paint will do the job. Paint the back side, not the front where decal is placed.
Using clear paint, green in my case, cover the area you want to be visible . Drill holes in the dashboard where the gages to be shown. Glue the acrylic panel to the dash.
Untitled by
Jack Reichman, on using scrap plastic make back wall of the shadow box and drill wholes to accommodate LEDs, as close as possible to where gages to be illuminated.
Stick some aluminum paper inside for reflection.
Glue the back of the shadow box and LEDs in place.
[IMG]
Untitled by
Jack Reichman, on Flickr[/IMG]
[IMG]
Untitled by
Jack Reichman, on Flickr[/IMG]