Thread: What kind of motor need in PMD reduction 4:1 ?
View Single Post
  #7  
Old 10-31-2015, 05:36 PM
fhhhstix's Avatar
fhhhstix fhhhstix is offline
Out of control
  
Join Date: Aug 2010
Location: Kirklin IN.
Posts: 3,788
fhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud of
Default Re: What kind of motor need in PMD reduction 4:1 ?
Quote:
Originally Posted by CarZep View Post
Thank you my friends for your help you where right the problem was the pinion.

I have another doubt, what motor would you recommend to put in an Integy 65t or Tamiya 33t? I am also putting a 4:1 reduction PMD. Thank you again
I use a 55 turn and a 4:1 or 3:1 in all of my trucks. I tried using higher turn motors and smaller pinions but I just wasn't happy with it. A 4:1 after the trans and a 55 turn will give you a lot of power but still have more than enough speed especially while at a show with other trucks
__________________
AKA "00" Biddle


RIP FreddyGearDrive 2-12-59/12-19-11
Reply With Quote