[Izzy]

First time. That support took at least 4 tries and 2 different material tries. First was a 2" wide 3/16 alum from lowes. Put it in the vise and pulled it over . Got all the way to the last bend and it fractured through. Great for a pinch flange horrible for forming....
then thought about brass. But didn't have anything long enough. Then tried this 1 x 1/8 also from lowes and it did great! But then had to make 3 just to get the blank versus finished item right. Alum is tricky stuff to figure a bend allowance and heck forming in a metal vise and pulling it over by hand isn't science either. So a good drawing would do me No good on this one. This is where I rely on my farm boy upbringing And back yard engineering