Quote:
Originally Posted by Exile Trucking
Good job on the nuckles. Two ?s how big of a block did the nuckle start as and do u have a 2 or 3 way vise for the mill. And please don't tell me you do all that great work with a regular vise. It would just put me to shame
|
I have a Soba 4" vice. It has swivel base(I've yet to use it) and some V notches in one jaw. That's it, nothing too fancy unfortunately.
The spindles started out as one block about 2"x1 1/4"x1 1/2".
Lunch is over....back to work! Should have the front finished in a couple hours
.
Reg