[9W Monighan]

Originally Posted by Cooper

Yeah, I see the possibility of a reprimand. Lol!!!

And yes this isn't on the cheep side. I did look at other materials but longevity won out. And went with this type. I really didn't spent much time with the part prior to making the mold. Figured equipment tire a few blemishes,,,,, I think I'm going to start working on a two piece rim and the axle next. Figure if a design change needs to happen better not make them all. I'm trying to make the weight of the truck on the axle and not on the motor shaft. Like a post of joes when he was building the adt. Any idea where to source 1 1/2 I d bearings that are not much bigger on the o.d.? And cheep?

For thin bearings, try looking here: http://www.ebay.com/sch/i.html?_from...earing&_sop=10



.