[scalelover]

Way do you guys think abut this setup? Conversational vs full cnc programs?

I have bobcad/cam at work but am looking at a secondary setup on a milling center. I've looked at a few and one that stands out is Prototrax. I have an ACER that can be converted, it looks like they replace my current dro setup and install all new hand controls and feeds etc etc.

Have any of you guys used or heard anything on their systems or conversions? I've got a few younger guys just learning design and programming and many people have said this type is a lot easier to use/learn than full out CNC programs. BUT I wonder how many drawbacks it brings as far as abilities and them using our other system. I'd mainly be using it for small runs and prototype stuff but wouldn't want to make it a confusing for the guys if they are bouncing between the two.

Any input is greatly appreciated on this guys.

--Dan