Quote:
Originally Posted by sleepiejay
So I have converted my first servo ( hitec 325hb) to 360 rotation by taking out the pot and replaced it with 2 resistors of the value. It works well but a little hard to center or stop, I can deal with that. The problem is when I turn it off and then back on to use it again it starts turning slowly. I can us the trim to stop it but just wondered if I missed somthing ?
|
what i did was just take the esc out of the servo and used a small 1/18 scale esc. the reason was the creep on my track loader was so bad it was almost un-driveable but also i've found that some companys servo are better then other at 360 converts futaba's work better the hitec and both work better the traxxas and china brands