Wow it has been a while since I have visited this thread. Since my last post here I have added a new work bench last fall and yesterday I got some new stuff for the mill.
The new bench.
The new tools.
Vice!
Replacing this POS!
Clamp set.
And what you can't see is the conversion kit for the mill to make it a true inch table. Before one turn of the crank = .0625 and now one turn = .050 making it much easier to keep track of what you are doing. I have also been using cent bits as I call them to start my holes so I get the hole exactly where I want it. Yes it is a pain to start the hole then change to the drill bit to finish the hole but the final product is a lot nicer. Here is a pic of what I am talking about.
Thanks for looking.
Travis