View Single Post
  #4  
Old 04-17-2018, 07:34 AM
bigdogrod bigdogrod is offline
Green Horn
 
Join Date: Aug 2011
Location: maryland - 20814
Posts: 264
bigdogrod is on a distinguished road
Default Re: 3d printed flip bumper mount

well version 1 complete fail... lol

the links are smaller than a penny and won't hold up to the stress, also the servo needs to move down 15mm to clear the steering and shift servos

version 2 was done as a conventional singe point hinge, but it runs into the same problem i thought it would, there'd no room to tilt the bumper without hitting the body, so it's back to the drawing board for the 2 point hinge. the bumper needs to drop a bit, then flip.
Reply With Quote