Re: Stahl dozer gear boxes and drive motors
Eddie, in my box of gears i had long pinion gears that were long enough to reach. If you search the net you should be able to find some. You only need about 2mm of shaft in the gear to hold it well because there is much less torque/stress applied on the pinion than on the gears further out in the gear train. clean the shaft and gear well with rubbing alcohol. Place a drop of original JB weld on the pinion before you push it on and let it sit for 24hrs before you touch it again. Good luck and have patience.
__________________
Scott
"No load is too Small"
|