[ihbuilder]

still milling parts yet and need some different size screws . (no bolt place open on Christmas ) I tried to take a pic of the pivot parts being milled , not to good so I got 1 of the screen .













I'm using pretty much what Chris did , just going a little bit further with the track frame pivot point . I'm doing away with the single point pivot to the inside of the track frame which would wear over time causing the track frame to come out of alignment thus , alowing the track to come off . the 1's I'm building is similar to the real 1's not as detailed but will function the same .

thanks for lookin

Ben , pic of the insides