View Single Post
  #2  
Old 02-08-2011, 06:44 PM
9W Monighan's Avatar
9W Monighan 9W Monighan is offline
Big Dawg On The Bone
 
Join Date: Aug 2010
Location: Pittsburgh,PA.
Posts: 1,283
9W Monighan will become famous soon enough9W Monighan will become famous soon enough
Default Re: What mill to buy

Review a past post on this subject.
I know a guy with a Sherline and he likes it but it takes forever to mill larger pieces that will fit on the table. He did have to send the table back and get a new one because it wasn't machined properly. He uses BobCad software for programming. If I was looking at a bench mill, I would try to go a tad bit heavier .
Reply With Quote