View Single Post
  #18  
Old 07-20-2017, 02:32 AM
sassgrunt sassgrunt is offline
Newbie
 
Join Date: Dec 2011
Posts: 83
sassgrunt is on a distinguished road
Default Re: Thoughts on the RC4WD BEAST II 1/14?

Well, if you used a Globeliner as a basis, you COULD still make it a 6x6 by using a TLT axle on the front. Then, you use the inside half of a dual (rear) wheel on that axle, and it makes it about the same width as the rear axles with the dual wheels, (about 7" wide).

Now, another option using these same axles, (and I'm doing this on a Pixar Mack Hauler I'm making for my grandson), is to use "wheel spacers" on the rear axles, which will bring all three axles to the same width, (about 8" wide). The type I used is similar to these: http://www.ebay.com/itm/4-12mm-Hex-W...oAAOSwB09YPii5 -Mike

Last edited by sassgrunt; 07-20-2017 at 02:49 AM.
Reply With Quote