Thread: Help, 4200XL Excavator Electronics?
View Single Post
  #16  
Old 10-20-2014, 06:36 PM
fhhhstix's Avatar
fhhhstix fhhhstix is offline
Out of control
  
Join Date: Aug 2010
Location: Kirklin IN.
Posts: 3,788
fhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud offhhhstix has much to be proud of
Default Re: Help, 4200XL Excavator Electronics?
Quote:
Originally Posted by thebigo View Post
So, Diagnosed it with the help of Modelman and Cooper down to the drive ESC's. Took the Swing Esc and put it on one side of the drive motors and it worked for both reverse and forward. fhhhstix, Are you talking about the programing of the ESC's or for operation as well? I wish I could find the programing operation for these? With my armageddon dump i could never figure out the programing on it, and RC4WD couldn't provide me with anything either, so they sent me a new ESC for the hydraulic's . The Esc's are most likly shot, I sent a message with vidio to RC4wd see if they can help.
For operation as well all of the on/off switches except the pump esc should be in the off position. Turn them OFF because in the on position all they are doing is powering the receiver so turn them off and let the pump esc run the receiver. With them on you are back feeding to the esc's
__________________
AKA "00" Biddle


RIP FreddyGearDrive 2-12-59/12-19-11
Reply With Quote