Hey guys I had alot of positive feedback on my snowblower project so I thought I would go ahead and share it here as well. It is a 3d printed snowblower designed by Spyker workshop. Have to apologize for the bad driving because this was literally the first and only time I have driven it because we barely have any snow fall right now so I had to hand shovel the snow into piles just for a video. It works great! I finished up the driveway driving from my living room. The brushless setup on the blower itself has power to spare for when we get deeper snow, its just over 50% throttle right now I believe.
https://www.youtube.com/watch?v=4XG0HAsMtSI