[Cooper]

Now the craziness starts!!! The trailer is 7" wide (same as edges of tires on truck ) with the side extensions adding almost one inch to each side for a total extended width about 8 3/4- 8 7/8" wide almost 9". The excavator will have a good 75% of each track on trailer. I'm estimating 11 of these on each side. To facilitate not having a workforce of elves I decided to make this jig. I will be able to "pinch" the tubes the shafts run through so when not in use they will lay flat against inner frame rail. Originally I was going to make removable ones and add a compartment in frame to house them but these will pull from the imperfections in my welding my eyes are trained on. I thought about cutting holes in them but some of the 1:1 supports are solid so I'm keeping them solid. And only have to drill one hole in top of ibeams for shaft to slide through. Then the decking will hide holes.