Quote:
Originally Posted by TheMachinist
Boy it's really coming along!
I have a question. I see that the bolt holding the servo in place seems to go right through the case. Is there room in side the servo for it to clear all the electronics or have you moved stuff to make it work?
|
The servo is only drilled through just behind the pot on it where the casing is hollow. I chose it directly center of the ram and just behind there for the best center pivot point to the actual ram. There is no modification other than what I have done for full rotation to the electronics. I will be using a piece of brass tubing running through with a wrist pin to pivot on like a normal cylinder would so everything will be encased. The screws are just temporary holders and work great.