Been a long winter with many distractiond, but with the help of a good couple friends getting the bug to build again.
So if some of this is repetitive - appologies. But this is where I am at.
Lift cylinders, another learning curve here. Thought that sir fittings were air tight right? Not so much. Have to replace the fittings, they leak.
Over all shot, not bad. Going to use an idea from a fellow member on the wheel inserts. Stock foam just way too soft and machine way too heavy. Craft foam sheets is where I am headed.
Boom sections -just finished bolting up. Need spools - friends are priceless.
Had to have the caps remade since I designed them too small the first time round.
