[RCP57]

Nothing really went as planned for me today but I did get started on the rear wheels and finished my spare. For the rear wheels I am attempting to stamp out the centers, do a little machining and then press them into the rim. So far I have made a couple of dies and successfully punched out one center to play with. I am not sure what I will end up doing as it is kinda trial and error at this point. I will try to mess around with this a little more over the next couple of days and nail down a setup.

This is what the first one looks like prior to drilling the bolt circle. I will put it back in the lathe to clean up the edge where the center meets the rim eventually.