RC Truck and Construction  

Go Back   RC Truck and Construction > RC Truck's Ag and Industrial Equipment and Buildings > Construction Equipment

Construction Equipment If it digs, pushes, hauls dirt "off road" post it here.


Reply
 
Thread Tools Display Modes
  #1  
Old 07-23-2019, 04:44 PM
larsra larsra is offline
Newbie
 
Join Date: Feb 2017
Posts: 12
larsra is on a distinguished road
Default Dimmensions on hydraulic lines - Liebherr 954 Excavator

Hi!

As I did not manage to post a thread in "Construction Equipment Tech", I will have it a go here.

My question is about the dimensions on the hydraulic lines in general. The inside of the M5 nipples used for 4mmOD/2.5mmID hose, is slightly below 2mm inside.
On my excavator I have used 4mmOD/3mmID copper pipes as hydraulic lines at the boom. Is it any point using lines with 3mmID when the nipples only got below 2mmID?

Given that the longest copper line is 50cm at the boom, could 1mm smaller ID excess any extra heat or is 50cm too small to make any difference?
Reply With Quote
  #2  
Old 09-03-2019, 03:39 AM
skeeter skeeter is offline
Big Dawg On The Bone
 
Join Date: Jul 2017
Location: Washington State
Posts: 1,732
skeeter is on a distinguished road
Default Re: Dimmensions on hydraulic lines - Liebherr 954 Excavator

I'm no hydraulic expert.............As I understand it, it's always better to go from bigger to smaller. This allows for the fluids to flow better due to being pressurized more. It's kind of like a trash pump, 2" suction tube, goes well with a 1 1/2" discharge tube. This gives good lift pressure to move the fluid.
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:37 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.