Great Dane excavating co.

[Cooper]

Yeah I need to start getting stuff around for the show also. Messed up my shoulder with work stuff, can't lift above my head so hand cranking wheels at home has been therapy . You are right about that gear stock being easy to cut. I guess I base my steel experience on hardware store stock. Doesn't cut well, and never a good finish. Last project I got steel ordered, easy to machine kind. Slowly learning to get the correct materials to make the job easier. That shaft wasn't bad to cut my inexperience showing again.



The smaller gear on shaft is the one inserted into gearbox, it will be keyed to shaft. Top gear will be connected to a driveshaft. Only hard part now is getting the correct spacing on gears into gear housing.