|
Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Trying to make a gear pump
Hi forum,
I'm new here but have been reading alot about your fine projects. I have a small lathe and a small vertical mill and wanted to build a gear pump, later some valves and cylinders, just for fun and maybe it will end up with a wheel loader build of some sort. Anyways, I have these module 1 10T gears I want to use for the gear pump. The flange section has to go for the gear to be used in a pump. Now how do I fasten the gear to the axle without the flange to drill and tap for a set screw? The gear has a 4mm hole, the axle is a 4mm surface hardened pin. Please advise :-) Thanks. Best regards, Martin from Denmark |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|