|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#6
12-04-2010, 12:32 AM
|
||||
|
||||
Re: Thread tap suggestion
Spiral point tap is what I have, as I notice the chips being pushed forward. Using it for a blind hole is time consuming & the necessity for pressurized air to clean the hole often, as well as drilling a deeper hole than necessary. Need to get a "spiral flute" tap for blind holes.
 Gosh it's GREAT having a journeying machinist on the forums, learning lots. Thanx for taking the time to edumacate us. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode