Scaleart - assembling an Arocs 8x8 roll on roll off kipper

[Rakthi]

A small update. Prepped the front lights for fit of the LEDs. Not a big job but at least it is out of the way.

Checked the tracking I got and the package from ScaleART has cleared customs in Kuala Lumpur. So now waiting for it to make it here. With some luck might get here beginning next week so we can get on with this.

Here the housing with the LED board. You can see that some of the openings are not completely open.



Trial fitting showed that the circled opening was too narrow also.



Tools used for "fixing" the smallest drill bit in the Dremel collection (1/32" for the Americans) and a small round file.





2 twists with the file and perfect fit.





Both sides had same treatment.

Since I got them and for completeness sake, here a pic of front and back of the PistenKing LED boards