|
|
|||||||
| Truck Building Tech Covers mechanical and electrical components for truck modeling |
|
|
Thread Tools | Display Modes |
|
#4
05-13-2016, 12:23 PM
|
||||
|
||||
Re: Question about rear frame member
Oh ok if you are using some aftermarket blank frame rails then they might not have the exact same bends in the c channel and could require some light filing of the alloy part you posted above as it sits inside the rail at the back. Also obviously you would have to drill the two mounting holes either side for your screws (amongst all your others).
__________________
4 tractors/trailers and still no king hauler... 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode