Great Dane excavating co.

[Cooper]

Originally Posted by Mech_Eng

Good lookin' parts! I just ordered a Tormach 770 about an hour ago, I think you and your thread are partly to blame I'm looking forward to your loader build, we have a 990 at work with forks on it, its our 40ton forklift!

I have been told (usually by law enforcement and teachers) that I am a bad influence !!!!! the 770 spins up to 10k , that is a big benefit!! still in the learning process but machine is doing everything it should. solid right out of the crates, I did have to place a .005' shim under one corner, tramed it in with indicators then test cuts, perfect now. was perfect before but one mistyped offset put a 3/8 mill into the workpiece hard. so I checked it after that. really is a turnkey set up , keep me posted on anything you make.