ADT build

[Efroeh]

Originally Posted by SteinHDan

The switches look to be in the right position. Could you also share a picture of it when you have the servo cable connected?

And if it still doesn't work, maybe try the switch in "S" position also?
Here is a lot more info on the servo:
- https://www.aliexpress.com/item/Free...899809165.html

And a couple of demo videos:
- https://www.youtube.com/watch?v=rPN92jVIs6o
- https://www.youtube.com/watch?v=GwRxrp4nzDA

The servo is supplying 5V on the 5V servo lead and it can power your receiver this way, but if you are powering your receiver from a different source, then disconnect this red lead on the servo cable. Also, it can only supply 20ma 5V, so if you have any other normal RC servo on the same receiver I suggest disconnecting the red servo wire and power the receiver from some other power source.

Stein :-)

I'm gonna try it again tonight I will use it to power my servo and see if that'll make a difference. also the link for more info just said it was not avaible anymore.