Fully 3D printed John Deere 1/10 scratch build

[agriRC]

I have done some research and found my 30mm fan throughput is 4.12 CFM. This is obviously not enough. Ideally I would like to treble this so will require a 50mm fan. So a re-design of the enclosure is required. Handy for for you guys to know for the anyone who wants to build there own smoke generator. I cannot confirm a 50mm will work but fairly confident. The vape coil I used was a 0.85 ohm clapton coil. There are many different types of coils out there for vape modders. Any should work.