|
|
|||||||
| Metal forming & tools If it bends,twists,welds,cuts & turns metal.Post it here |
|
|
Thread Tools | Display Modes |
|
#2
02-08-2011, 06:44 PM
|
||||
|
||||
Re: What mill to buy
Review a past post on this subject.
I know a guy with a Sherline and he likes it but it takes forever to mill larger pieces that will fit on the table. He did have to send the table back and get a new one because it wasn't machined properly. He uses BobCad software for programming. If I was looking at a bench mill, I would try to go a tad bit heavier . 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode