Configure Spectrum DX6i with Tamiya MFU

[Mpfiend]

Gents,

After a couple of hours yesterday I set up my MFC-03 with my Spektrum Dx6i using the information posted in this thread and the instructions supplied.
This was only a bench test so far, as I have not yet started the build of the truck (I'm still getting the trailer built at the moment), but everything seems to work correctly. all of the sounds and modes seem to work without any fault. the only thing that I have not yet done is the gearbox set up, but the shift servo moves in the right directions when commanded. the coupling servo and switch are also operating correctly.
I'll post some more information once the truck build gets underway.

Thanks for looking in.

Best Regards

Keith