|
|
|||||||
| Construction Equipment If it digs, pushes, hauls dirt "off road" post it here. |
|
|
Thread Tools | Display Modes |
|
#31
09-13-2014, 09:45 AM
|
||||
|
||||
Starting on a NEW conveyor
Guys,
I'm starting on a new bigger conveyor. Question, I'm planning on turning the end drums on the lathe but HOW do I get a nice convex taper on them? I do not have power feeds so I can't imagine turning it slow enough and manually moving the cross feed and lateral feeds smooth and consistent enough to get a descent drum? Impossible to do without power feeds? Thanks Jim Last edited by Rvjimd; 09-13-2014 at 09:49 AM. Reason: Convex not concave 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode