|
|
|||||||
| Electronics tech Anything to do with the electronics in a model. Lights, Radio, ESC, Servo, Basic electrical. |
|
|
Thread Tools | Display Modes |
|
#2
09-20-2014, 09:53 AM
|
|||
|
|||
Re: Support legs motor voltage?
Travis would be correct that the legs only use 3v. I would try the winch controller at 3v and see what happens before increasing the voltage on the motor and possibly damaging it. If it won't work at 3v then you could always install a large load resistor to drop down the voltage from the minimum 6v that the controller uses to around 3v.
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode