4 Hour Bruder Dozer

[RCP57]

Originally Posted by justin

Hey reg
Nice looking tipper. Great job on the dozer

Thanks Justin. I guess we will see what you think of the tipper in about a week and a half hey?lol

Originally Posted by chet

looking good! How hard were those servos to convert to 360 rotation? I'm looking at the hs85mg's but they are quite a bit more

Thanks. These servos are already 360 rotation. I ordered some new ones this morning that are 13KG. Hopefully they will be strong enough to push a little dirt.

A little update. I spent a few hours today finishing up the tracks. I TIG welded 112, 4-40 nuts onto the chain. This took approximately an hour and a half. Then I proceeded to cut, drill and slot 56 pads. After that I bolted it all together and took some pictures. I took a test drive too but will make a video of that after I finish up the rollers under the track frames. Next up will be a new C frame for the blade!

I would also like to add that this is all Mario's fault!