|
|
#11
12-14-2014, 12:17 PM
|
||||
|
||||
Re: Great Dane excavating co.
Some of the process to make those little ends for the hard lines. Just a lot of processes for a bunch of these little pieces.
Facing cut  Center drilling  5/32 slightly under hole  Threading hole .25 deep  Tapping for m5 thread  Beveled end  Slightly over 5/32 for solder .10 deep  Had to make 14 if um. These little buggers were time consuming !!!
__________________
Always wasting money, as the wife says. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. 
|
| Currently Active Users Viewing This Thread: 35 (0 members and 35 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode