|
|
|||||||
| Construction Equipment Tech Hydraulics, Electronics, General Engineering, ect in constr equip |
|
|
Thread Tools | Display Modes |
|
#2
07-31-2016, 04:44 PM
|
|||
|
|||
Re: 4200 XL shear pin repair
So for now, until someone fixes this for me, you will have to click on the links.
The two little set screws on the outer cap that are 180 degrees from each other need to be removed completely, both of them  Mark positive pole on the motor and unsolder the wires to make this much easier.  Remove the cap. If it hangs, there may be broken pieces of the shear pin that interfere, this should just lift off easily. Then the motor comes right out. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode