|
|
#11
05-25-2020, 11:03 PM
|
||||
|
||||
Re: LilGiantsConstrCo
 Before   After... you can see how hilly it is throughout its length; I need to get started on my next project, a pull grader with powered axles connected to the 4206 to get the peaks & valleys leveled out, as well as a slope of 1” drop per foot to the trees...   My L12-50-216-6R actuators showed up today, I think they will do just fine tipping the load... the 4 EverReady (less than 4.8v) batteries I used with my servo tester are a couple yrs old, and tipped the heavy metal frame upward without much grunt. Do a lil temporary wiring tomorrow & put it through its paces.   
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get! Joe 
|
| Currently Active Users Viewing This Thread: 12 (0 members and 12 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode